Under-Bed Storage Drawers Plan
Build a PAIR of low rolling storage drawers sized to fit under a standard bed — each drawer 36 x 24 inches outside, with a solid pine face, a plywood box, and four swivel casters. Total height is 6-1/4 inches, worked out layer by layer in the plan (3-1/2 in walls + 1/2 in bottom panel + 3/4 in caster pads + 1-1/2 in casters), so it fits a typical 7 inch under-bed gap with 3/4 inch to spare — and the plan's first step is measuring YOUR bed, with an honest adaptation if your clearance is smaller.
This is a beginner-first plan, not a one-page cut list. Every term is defined at first use, you build a practice corner on scrap before touching the good plywood, and every technique step has its own labeled diagram (10 illustrations), a stop-and-check checkpoint, and fixes for the common mistakes. The construction is checked on paper: the walls rest ON a full bottom panel (real bearing — the bottom is never face-nailed to edges), the panel is supported by four solid caster pads and a center skid, and no screw ever bites into a plywood edge — corner screws bite 3/4 inch into solid pine corner blocks, face screws bite 3/4 inch into the solid face, and caster screws bite the full solid pad. Load math is stated, not guessed: 40 lb of contents per drawer is 13 lb per caster against casters rated 40 lb each.
You receive: a PDF plan with cut list, materials list, tool list, 35 continuously numbered steps, 10 diagram figures, measurement verification (height stack, screw bite, bearing, load), mistake fixes, and a final checklist, plus a materials estimate of $95-$140 for the pair.
DIGITAL DOWNLOAD: this listing is for the PDF building plan only. No physical product will be shipped. Print it or build from a tablet in the shop.
Full build plans and material list in the TheWorkshopBlueprint Etsy shop.
