Raised Dog Feeding Station Plan
Build an elevated dog feeding station that holds two stainless bowls at a height fitted to YOUR dog, with a hinged-lid dry-food storage bin underneath — 28 x 14 inches outside, 12 inches tall at the feeding surface as drawn, with legs that adjust the finished height anywhere from 10 to 18 inches by changing one part.
This plan is honest about fit in both directions. Height: you measure your own dog floor-to-brisket (the lowest chest point) and set the lid at that height or 1-2 inches below — the breed ranges in the plan are a sanity check only, and the plan says so. Bowls: there is no hole size printed from a chart. You measure your own bowls' flange and body diameters, build a paper template first, and cut only when the template proves at least 3/8 inch of flange bearing all the way around the hole (the worked example: 9 inch flange, 7-3/4 inch body, 7-7/8 inch hole, 9/16 inch overlap).
This is a beginner-first plan, not a one-page cut list. Every term is defined at first use, you build a practice corner joint on scrap before touching the good plywood, and every technique stage has its own labeled diagram (10 illustrations), a stop-and-check checkpoint, and fixes for the common mistakes. The construction is checked on paper: the hinged lid rests ON all four bin walls, the walls rest ON a full bottom panel, and the panel rests ON four corner legs (full 28 x 14 inch stance) plus a screwed base-trim frame — and no structural screw ever bites into a plywood edge; corner screws bite 3/4 inch into solid pine corner blocks and trim screws bite 3/4 inch into leg faces. Lid safety is built in, not bolted on: a pinch-point briefing, a pull-cleat grip (never the lid edge), and a lid support that holds the lid open and slows its close — required if children will open the bin. Load math is stated: two brim-full bowls, a full bin, and a 25 lb dog-nudge allowance total about 73 lb, roughly 18 lb per leg.
You receive: a PDF plan with cut list, materials list, tool list, 36 continuously numbered steps, 10 diagram figures, measurement verification (dog sizing, bowl template math, height stack, screw bite, bearing, load), mistake fixes, and a final checklist, plus a materials estimate of $55-$85 (bowls not included).
DIGITAL DOWNLOAD: this listing is for the PDF building plan only. No physical product will be shipped. Print it or build from a tablet in the shop.
Full build plans and material list in the TheWorkshopBlueprint Etsy shop.
